17" x 6.50" Over Lug Design Simulator Set
8 Lugs, 4 Hand Holes
Ford 2005-Current

17" x 6.50" Over Lug Design Simulator Set
8 Lugs, 4 Hand Holes
Ford 2005-Current

Fits the following dual rear wheel vehicles:

2005 – Current Ford F350, Rim #29837

17" x 6.50", 4 Hand Holes/Air Holes and 8 Lug Nuts

One set includes:
2 Front Liners/Dishes with Pop-off Hub Covers
2 Rear Liners/Dishes
16 Jam Nuts (M14xP1.5 thread)
1 Tool

These are 304-Grade Stainless Steel. You just need soap and water to clean them up!

INSTALLATION INSTRUCTIONS:
Application applies to original equipment manufacturer’s standard production wheels only.
There is no need to jack up your vehicle or to remove any lug nuts when installing this wheel liner set.
1. Install the liner on to the wheel
2. Screw the jam nuts down on the studs extending up through the lug nut holes in the liners. There are four (4) extra jam nuts for each wheel.
3. Using the tool provided with your wheel liner set, hand-tighten the lug nut covers with nuts. DO NOT use a power wrench for this purpose.
Installation is complete!

Picture shows 1/2 set, 1 front & 1 rear plus hardware. Each box contains complete set for 4 wheels.

OVERSIZED SHIPMENT – Dimensional Weight Applies

SOLD ONLY IN FULL SETS